MC35i AT Command Set

MC35i AT Command Set16.18 AT^SRTC16.18 AT^SRTC Ring tone configurationThe AT^SRTC read command returns the current and current . The read command can beused while test playback is off or on. In the latter case, see execute command for details.The AT^SRTC execute command is intended for testing. It starts to play a melody from the audio output currentlyselected with AT^SNFS. To deactivate test playback use AT^SRTC again.During test playback, you can enter the write command to select another melody and adjust the volume. Also,you can enter the read command to check the type and volume of the current ring tone, and to view the statusof playback (on / off). The test ringing signal cannot be activated when an MTC is ringing (ERROR).Selecting =0 during the test, immediately stops playback. After this, ring tones will be muted until youchange using the write command.The AT^SRTC write command chooses the type and volume of ring tones for the selected event. The settingscan be changed no matter whether or not the ME is ringing. The selected type and volume are saved in the nonvolatileFlash memory and, thus, are retained after Power Down. An exception is =0, that can be enteredto quickly mute the tone or melody currently played to indicate an event. =0 only stops immediately theaudible ring tone, but does not terminate the URC that indicates the event (for example RING). No permanentsettings are changed or saved.SyntaxTest CommandAT^SRTC=?Response(s)^SRTC:(list of supported) s, (list of supported) s, (list of supported) sOKRead CommandAT^SRTC?Response(s)^SRTC: (of =0) , (of =0) , (of =1) , (of=1), OKExec CommandAT^SRTCResponse(s)OKWrite CommandAT^SRTC=[][, ][, ]Response(s)^SRTC: , OKERRORReference(s) PIN ASC0 MUX1 MUX2 MUX3 Last-- ! % % % % ! !MC35i_ATC_V02.00nConfidential / ReleasedPage 343 of 3909/10/08