MC35i AT Command Set

MC35i AT Command Set2.8 AT+CFUNUnsolicited Result CodesURC 1^SYSSTARTIndicates that the ME has been started and is ready to operate. If autobauding is active (AT+IPR=0) the URCis not generated.URC 2^SYSSTART CHARGE ONLY MODEIndicates that the ME has entered the CHARGE ONLY mode. This occurs if the charger is connected whilethe ME is in POWER DOWN mode. If autobauding is active (AT+IPR=0) the URC is not generated. InCHARGE ONLY mode the ME is neither registered to the GSM network nor are the serial interfaces fullyaccessible. Only the AT commands listed in Section 19.4, Availability of AT Commands Dependingon Operating Mode of ME can be used. For further details on charging refer to the Hardware InterfaceDescription [2].Parameter Description (num) 9/10/080 NON-CYCLIC SLEEP mode:In this mode, the AT interface is not accessible. Consequently, after setting=0, do not send further characters. Otherwise these characters remainin the input buffer and may delay the output of an unsolicited result code.The first wake-up event stops power saving and takes the ME back to full functionalitylevel =1.[1] (&F) Full functionality.If the ME is in one of the CYCLIC SLEEP modes you can issue AT+CFUN=1to stop power saving and return to full functionality.Keep in mind that, unlike the reset command described below, this action doesnot restart the ME but only changes the level of functionality. See parameter for details on the reset.5 CYCLIC SLEEP mode:In this mode, the serial interface is shortly enabled while CTS is active. If charactersare recognized on the serial interface, the ME stays active for 2 secondsafter the last character was sent or received.6 CYCLIC SLEEP mode:In this mode, the serial interface is shortly enabled while CTS is active. If charactersare recognized on the serial interface, the ME stays active for 10 minutesafter the last character was sent or received.To ensure that power saving takes effect immediately, the ME stays active foronly 2 seconds after =6 was entered.7 CYCLIC SLEEP mode:In this mode, the serial interface is shortly enabled while CTS is active. If charactersare recognized on the serial interface, the ME stays active for 2 secondsafter the last character was sent or received. ME exits SLEEP mode only, ifAT+CFUN=1 is entered.8 CYCLIC SLEEP mode:In this mode, the serial interface is shortly enabled while CTS is active. If charactersare recognized on the serial interface, the ME stays active for 10 minutesafter the last character was sent or received. ME exits SLEEP mode only,if AT+CFUN=1 is entered.To ensure that power saving takes effect immediately, the ME stays active foronly 2 seconds after =8 was entered.MC35i_ATC_V02.00nConfidential / ReleasedPage 36 of 390