MC35i AT Command Set

MC35i AT Command Set19.8 Alphabetical List of AT CommandsAT Command Description Section and PageAT^SPBG Display phonebook entries in alphabetical order Section 15.7, page 314AT^SPBS Step through the selected phonebook alphabetically Section 15.8, page 317AT^SPIC Display PIN counter Section 5.3, page 95AT^SPLM Read the PLMN list Section 8.10, page 165AT^SPLR Read entry from the preferred operators list Section 8.11, page 166AT^SPLW Write an entry to the preferred operators list Section 8.12, page 167AT^SPWD Change Password Section 5.7, page 109AT^SRTC Ring tone configuration Section 16.18, page 343AT^SSCONF SMS Command Configuration Section 12.22, page 287AT^SSDA Set SMS Display Availability Section 12.23, page 288AT^SSET Indicate SIM data ready Section 13.3, page 295AT^SSMSS Set Short Message Storage Sequence Section 12.24, page 289AT^SSTA SAT Interface Activation Section 14.1, page 298AT^SSTGI SAT Get Information Section 14.3, page 301AT^SSTR SAT Response Section 14.4, page 302AT^SSYNC Configure SYNC Pin Section 17.5, page 356AT^STCD Display Total Call Duration Section 7.26, page 145ATA Answer a call Section 7.1, page 116ATD Mobile originated call to specified number Section 7.2, page 117ATD*98# Request GPRS IP service Section 10.14, page 218ATD*99# Request GPRS service Section 10.13, page 217ATD>ATD>ATD>Mobile originated call using specific memory and indexnumberMobile originated call from active memory using indexnumberMobile originated call from active memory using correspondingfieldSection 7.3, page 119Section 7.4, page 121Section 7.5, page 122ATDI Mobile originated call to ISDN number Section 7.6, page 123ATDL Redial last number used Section 7.7, page 124ATE Enable command echo Section 4.5, page 80ATH Disconnect existing connection Section 7.8, page 125ATHManual rejection of a network request for PDP context Section 10.15, page 219activationATI Display product identification information Section 6.1, page 110ATL Set monitor speaker loudness Section 16.2, page 323ATM Set monitor speaker mode Section 16.3, page 323ATOSwitch from command mode to data mode / PPP online Section 7.16, page 134modeATP Select pulse dialing Section 7.27, page 146ATQ Set result code presentation mode Section 2.4, page 31ATS0 Set number of rings before automatically answering a call Section 7.11, page 129ATS10Set disconnect delay after indicating the absence of datacarrierSection 7.15, page 133MC35i_ATC_V02.00nConfidential / ReleasedPage 389 of 3909/10/08