MC35i AT Command Set

MC35i AT Command Set10.6 AT+CGQMIN10.6 AT+CGQMIN Quality of Service Profile (Minimum acceptable)SyntaxTest CommandAT+CGQMIN=?Response(s)+CGQMIN: , (list of supported s), (list of supported s), (list ofsupported s), (list of supported s), (list of supported s)OKERROR+CME ERRORRead CommandAT+CGQMIN?Response(s)[+CGQMIN: , , , , , ][+CGQMIN: ...]OKERROR+CME ERRORWrite CommandAT+CGQMIN=[[, [, [, [, [, ]]]]]]Response(s)OKERROR+CME ERRORReference(s) PIN ASC0 MUX1 MUX2 MUX3 LastGSM 07.07 % % % % % ! !Command DescriptionThe test command returns values supported as a compound value. If the MT supports several PDP types, theparameter value ranges for each PDP type are returned on a separate line.The read command returns the current settings for each defined context. If no minimum profile was explicitlyspecified for a context, simply OK will be returned, but default values will be used for that context.This command allows the TE to specify a minimum acceptable profile which is checked by the MT against thenegotiated profile returned in the Activate PDP Context Accept message.The set command specifies a profile for the context identified by the (local) context identification parameter,.A special form of the set command, AT+CGQMIN= causes the minimum acceptable profile for contextnumber to become undefined. In this case no check is made against the negotiated profile.AT&F and ATZ will undefine the minimum QoS profiles of every context which is not active or not online.Parameter Description (num) 9/10/08Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and isused in other PDP context-related commands.1...2MC35i_ATC_V02.00nConfidential / ReleasedPage 202 of 390