MC35i AT Command Set

MC35i AT Command Set2.13 AT^SCFG (str)(+CSCS)AutoExec Command IndexThis parameter specifies the command storage index. The following table shows the index ranges supported foreach variant of .Value will be saved while switching off the MC35i via AT commands (e.g. AT+CFUN or AT^SMSO) and restoredon next power up. value event Valid Indices0 Autoexec activity is driven by ASC0 DTR 0line activation1 Autoexec activity is timer driven. 0-2 (str)(+CSCS)AutoExec Command Mode0...255This parameter specifies details regarding the behavior of the MC35i when the AT command starts to be executed.Value is interpreted as a bit field, unused bits are reserved for future use (RFU) and shall be set to 0.When a call is released by an Autoexec activity, no release indication may be issued on the first logical channel.If during a data call the MC35i temporarily enters command mode via +++ no AT command will be executed if specifies 'Ignore ongoing calls'.Value will be saved while switching off the MC35i via AT commands (e.g. AT+CFUN or AT^SMSO) and restoredon next power up.Bit Mask hex Mask dec ControlD 0D 10x000x010x020x03012300: Ignore ongoing calls01: Wait until all calls have ended10: Dismiss any ongoing call11: RFUD 2 0x04 4 0: One shot action1: Periodic action (for "AutoExec/Period" only)D 3 0x08 8 RFUD 4 0x10 16 RFUD 5 0x20 32 RFUD 6 0x40 64 RFUD 7 0x80 128 RFU (str)(+CSCS) 9/10/08AutoExec AT command StringThis parameter specifies the AT command(s) to be launched automatically. Each AT command is executed inthe same way as if it were entered online, this means that command concatenation is possible if supported bythe given commands. If serial multiplex mode is activated (AT+CMUX) the first logical channel is used, i.e. CSDcalls (data or fax) could be set up. If the MC35i is busy on the serial channel command execution will be delayeduntil ongoing action is finished.The first two characters of the automatically launched AT command shall be "at" and its length shall be less than25 characters.Please refer to examples below.Value will be saved while switching off the MC35i via AT commands (e.g. AT+CFUN or AT^SMSO) and restoredon next power up.MC35i_ATC_V02.00nConfidential / ReleasedPage 50 of 390