MC35i AT Command Set

MC35i AT Command Set17.3 AT^SBC17.3 AT^SBC Battery charge and charger controlPlease note that the AT^SBC command is intended only for use with the MC35i Module. It is not relevant for theMC35i Terminal.If the product is MC35i Module: The AT^SBC read command can be used to query the average current consumptionof the module. The AT^SBC write command determines the presentation of Unsolicited Result Codes usedto indicate undervoltage conditions.SyntaxTest CommandAT^SBC=?Response(s)^SBC:(list of supported s), (list of supported s), (list of supported s)OKRead CommandAT^SBC?Response(s)^SBC: , , OKERROR+CME ERROR: Write CommandAT^SBC=Response(s)OKERROR+CME ERROR: Reference(s) PIN ASC0 MUX1 MUX2 MUX3 Last-- ! % % % % ! !Unsolicited Result Code^SBC: UndervoltageThe URC will be sent if undervoltage is detected. If the module is in IDLE mode it takes typically one minute toderegister from the network and to switch off.Parameter Description (num)0 (P) Disables presentation of Undervoltage URC1 Enables presentation of Undervoltage URC (num)Connection status of charging adapter (not relevant for MC35i)0 No charging adapter is connected (num)Battery capacity (not relevant for MC35i)0 Indicates that no battery is available9/10/08MC35i_ATC_V02.00nConfidential / ReleasedPage 351 of 390