MC35i AT Command Set

MC35i AT Command Set11. FAX Commands11. FAX CommandsThe following commands can be used for fax transmission.If the ME is acting as a Fax modem for a PC based application (e.g. "WinFax") it is necessary to select the properService Class (Fax Class) provided by the ME. The ME reports its Service Class capabilities, both the currentsetting and the range of services available. This is provided by the AT+FCLASS command.Service Classes supported by the ME:AT+FCLASS Parameter Service class Reference, Standard0 Data modem e.g. TIA/EIA-602 or ITU V.2501 Service Class 1 EIA/TIA-578-A2 Manufacturer specific This document and EIA PN-2388(draft)The following AT commands are dummy commands:AT+FAA Auto Answer modeAT+FECM Error Correction Mode controlAT+FLNFC Page Length format conversionAT+FLPL Indicate document available for pollingAT+FMINSP Minimum Phase C speedAT+FRBC Phase C data receive byte countAT+FREL Phase C received EOL alignmentAT+FSPL Enable pollingAT+FTBC Phase C data transmit byte countAT+FWDFC Page width format conversionInvoking these commands will not cause ERROR result codes, but these commands have no functionality.11.1 FAX parametersBelow you can find a summary of parameters used by the fax-specific AT commands and responses describedin this chapter. Please note that parameter is dedicated to Fax Class 1 only. All other parameters listedbelow are for Fax Class 2 only.Parameter Description (num)Modulation schemeTo find out which value is actually supported by use the test commands while the ME is off-hook.3 V21 Ch2 - 300 bps24 V.27ter - 2400 bps48 V.27ter - 7200 bps72 V.29 - 7200 bps96 V.29 - 9600 bps (num)Binary File Transfer Mode[0] Disable BFT1 Enable BFT9/10/08MC35i_ATC_V02.00nConfidential / ReleasedPage 223 of 390