MC35i AT Command Set

MC35i AT Command Set4.7 AT+IPR- MC35i Terminal version: autobauding should not be used at bitrates over 115200bps.• Autobauding and bit rate after restartThe most recently detected bit rate is stored when the ME is powered down (with AT^SMSO). Therefore, eachtime the module is restarted the correct bit rate must be found as described above. Unless the bit rate is determined,the following constraints apply:- An incoming CSD call cannot be accepted. This must be taken into account when autobauding andautoanswer mode (ATS0 ≠ 0) are enabled at the same time, escpecially if SIM PIN 1 authentication is doneautomatically and the setting ATS0 ≠ 0 is stored to the user profile with AT&W.- Until the bit rate is found, URCs generated after restart will be output at 57600 bps. This applies only touser defined URCs, such as "+CREG", "CCWA", "^SCKS" etc. The URCs "^SYSSTART" and"^SYSSTART ALARM MODE" will not be indicated when autobauding is enabled.Note: To avoid any problems caused by undetermined bit rates in the direction from TA to TE we stronglyrecommend to configure a fixed bit rate rather than autobauding.• Autobauding and multiplex modeIf autobauding is active you cannot switch to multiplex mode (see AT+CMUX).MC35i_ATC_V02.00nConfidential / ReleasedPage 85 of 3909/10/08