MC35i AT Command Set

MC35i AT Command Set10.7 AT+CGQREQ10.7 AT+CGQREQ Quality of Service Profile (Requested)SyntaxTest CommandAT+CGQREQ=?Response(s)+CGQREQ: , (list of supported s), (list of supported s), (list ofsupported s), (list of supported s), (list of supported s)OKRead CommandAT+CGQREQ?Response(s)[+CGQREQ: , , , , , ][+CGQREQ: ...]Write CommandAT+CGQREQ=[[, [, [, [, [, ]]]]]]Response(s)OKERROR+CME ERRORReference(s) PIN ASC0 MUX1 MUX2 MUX3 LastGSM 07.07 % % % % % ! !Command DescriptionThe test command returns values supported as a compound value. If the MT supports several PDP types, theparameter value ranges for each PDP type are returned on a separate line.The read command returns the current settings for each defined context. If no requested profile was explicitlyspecified for a context, simply OK will be returned, but default values will be used for that context.This command allows the TE to specify a Quality of Service Profile that is used when the MT sends an ActivatePDP Context Request message to the network.The set command specifies a profile for the context identified by the (local) context identification parameter,.A special form of the set command, +CGQREQ= causes the requested profile for context number to become undefined.AT&F and ATZ will undefine the QoS profiles of every context which is not active or not online.Parameter Description (num)Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and isused in other PDP context-related commands.1...2 (num) 9/10/08Precedence class[0] network subscribed value1 High PriorityService commitments shall be maintained ahead of precedence classes 2 and3MC35i_ATC_V02.00nConfidential / ReleasedPage 206 of 390