Christie LW600 Serial Communications Protocol-Expanded

Status Read Commands8.4.7 CF_APCTRL CommandCommand“CF_APCTRL_%1” [CR]%1 “L1” - Set Auto Picture Control to Level 1.“L2” - Set Auto Picture Control to Level 2.“OFF” - Set Auto Picture Control OFF.“ UP” - Switch setting forward direction (OFF→L1→L2→OFF)“ DN” - Switch setting backward direction (OFF→L2→L1→OFF)Detail Set Auto Picture Control (Available only in the normal Power ONstatus)The value set by this command is not stored in the projector’smemory. Therefore, when the power is turned to ALL OFF status, thevalue returns to the original setting. (It is stored in Suspend mode.)Response Acceptable “000” [CR]Unacceptable“Error Code” [CR]8.4.8 CF_COLTEMP CommandCommand“CF_COLTEMP_%1” [CR]%1 “000” – “003”Detail Set Color Temperature (Available only in the normal Power ONstatus)The value set by this command is not stored in the projector’smemory. Therefore, when the power is turned to ALL OFF status, thevalue returns to the original setting. (It is stored in Suspend mode.)Response Acceptable “000” [CR]Unacceptable8.4.9 CF_WBAL- CommandCommand“Error Code” [CR]“CF_WBAL-%1_%2” [CR]%1 “R” - RED“G” - GREEN“B” - BLUE%2 “000-063”- Directly specify value of Color selected in %1 of WhiteBalance.“UP”- Increment setting value of Color specified in %1 of WhiteBalance by 1“DN”- Decrement setting value of Color specified in %1 of WhiteBalance by 1Detail Set value of Color specified in %1 of White Balance (Available only inthe normal Power ON status)The value set by this command is not stored in the projector’smemory. Therefore, when the power is turned to ALL OFF status, thevalue returns to the original setting. (It is stored in Suspend mode.)Response Acceptable “000” [CR]8-4 LW600-LX900-LX1000 RS232 Codes-Expanded Technical Reference Information020-000046-02 Rev 2 (07-2011)