Christie LW600 Serial Communications Protocol-Expanded

Status Read Commands8.9.6 CF_RCODE CommandCommand“CF_RCODE_%1” [CR]%1 “001” - Select Code 1“002” - Select Code 2“003” - Select Code 3“004” - Select Code 4“005” - Select Code 5“006” - Select Code 6“007” - Select Code 7“008” - Select Code 8“UP” - Switch forward (Code1→Code2→Code3 - - -→Code8→Code1)“DN” - Switch backward (Code8→Code7→Code6 - --→Code1→Code8)Detail Select Remote Control Code (valid only when in the normal PowerON status).The status set by this command is stored in EEPROM and the settingremains effective after the power is turned to ALL OFF status.Response Acceptable “000” [CR]Unacceptable8.9.7 CF_RSENS CommandCommand“CF_RSENS_%1” [CR]“Error Code” [CR]%1 “BOTH” - Select both front and back receiver of projector“FRONT” - Select only front receiver of projector“BACK” - Select only back receiver of projector“UP” - Switch forward (BOTH → FRONT → BACK → BOTH)“DN” - Switch backward (BACK → FRONT → BOTH → BACK)Detail Select location of infrared remote receiver of remote control(available only in the normal Power ON status).The status set by this command is stored in EEPROM and settingremains effective even after the power is turned to ALL OFF status.Response Acceptable “000” [CR]Unacceptable“Error Code” [CR]8-28 LW600-LX900-LX1000 RS232 Codes-Expanded Technical Reference Information020-000046-02 Rev 2 (07-2011)