Christie LW600 Serial Communications Protocol-Expanded

Status Read Commands8.9.18 CF_KEYDIS CommandCommand“CF_KEYDIS_%1” [CR]%1 “NONE” - RC & KEY are valid“RC” - RC is invalid“KEY” - KEY is invalidDetail Set the limitation of RC/KEY use (valid only when in the normalPower ON status).Response Acceptable “000” [CR]Unacceptable“Error Code” [CR]8.9.19 CF_SHUTRCPROT CommandCommand“CF_SHUTRCPROT_%1” [CR]%1 “ON” - Disable RC key from controlling Shutter (Protection On)“OFF” - Enable RC key to control Shutter (Protection Off)Detail Set valid/invalid of RC use on Shutter control function (valid onlywhen in the normal Power ON status).Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8.9.20 CF_SHUTKEYPROT CommandCommand“CF_SHUTKEYPROT_%1” [CR]%1 “ON” - Disable key on the top panel from controlling Shutter(Protection On)“OFF” - Enable key on the top panel to control Shutter (ProtectionOff)Detail Set valid/invalid use of key on the top panel on Shutter controlfunction (valid only when in the normal Power ON status).Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8.9.21 CF_SHUTH CommandCommand“CF_SHUTH_%1” [CR]%1 “005”-“180”-Specify setting time directly“UP” - Add 1 minute“DN” -Decrease 1 minuteDetail Set time of operating shutter management function (valid only whenin the normal Power ON status)The status set by this command is stored in EEPROM, and thesetting remains effective even after the power is turned to ALL OFFstatus.Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8-32 LW600-LX900-LX1000 RS232 Codes-Expanded Technical Reference Information020-000046-02 Rev 2 (07-2011)