Christie LW600 Serial Communications Protocol-Expanded

Status Read Commands8.5.4 CF_V-POS CommandCommand“CF_V-POS_%1” [CR]%1 “0000-nnnn” - Directly specify setting value of Vertical Position“nnnn” indicates maximum value, which is current (Total Line –Display Area V) value“UP” - Increment setting value of Vertical Position by 1“DN” - Decrement setting value of Vertical Position by 1Detail Set Vertical Position value in PC signal (available only in the normalPower ON status).The value set by this command is not stored in the projector’smemory. Therefore, when the power is turned to ALL OFF status,the value returns to the original setting. (It is stored in Suspendmode.)Response Acceptable “000” [CR]Unacceptable8.5.5 CF_CLAMP CommandCommand“CF_CLAMP_%1” [CR]“101” [CR]• When input is Video signal• When input is no signal%1 “0000-4095” - Directly specify setting value of Clamp“UP” - Increment setting value of Clamp by 1“DN” - Decrement setting value of Clamp by 1Detail Set Clamp value in PC signal (available only in the normal Power ONstatus).The value set by this command will not be stored in the projector’smemory. Therefore, when the power is turned to ALL OFF status, thevalue returns to the original setting. (It is stored in Suspend mode.)Response Acceptable “000” [CR]Unacceptable“101” [CR]• When input is Video signal• When input is no signal8-10 LW600-LX900-LX1000 RS232 Codes-Expanded Technical Reference Information020-000046-02 Rev 2 (07-2011)