Christie LW600 Serial Communications Protocol-Expanded

Status Read Commands8.4.13 CF_NZRED CommandCommand“CF_NZRED_%1” [CR]%1 “ON” -Set Noise Reduction to ON“OFF” - Set Noise Reduction to OFFDetail Set or Cancel Noise Reduction (available only in the normal PowerON status).The value set by this command is not stored in the projector’smemory. Therefore, when the power is turned to ALL OFF status, thevalue returns to the original setting. (It is stored in Suspend mode.)Response Acceptable “000” [CR]Unacceptable8.4.14 CF_PROGV CommandCommand“CF_PROGV_%1” [CR]“Error Code” [CR]%1 “ON” - Set Progressive scan to ON“FILM” - Set Progressive scan to Film mode“OFF” - Set Progressive scan to OFFDetail Set or Cancel Progressive scan (valid only when it is in the normalPower ON status).The value set by this command is not stored in the projector’smemory. Therefore, when the power is turned to ALL OFF status, thevalue returns to the original setting. (It is stored in Suspend mode.)Response Acceptable “000” [CR]Unacceptable“Error Code” [CR]8-6 LW600-LX900-LX1000 RS232 Codes-Expanded Technical Reference Information020-000046-02 Rev 2 (07-2011)