Christie LW600 Serial Communications Protocol-Expanded

Status Read Commands8.9.11 CF_PJPINCODE CommandCommand“CF_PJPINCODE_%1” [CR]%1 “0000 – 9999” - Directly specify PJ PIN codeDetail Enter PIN code to cancel PIN code lock (Available only in the normalPower ON status) PIN code can not be changed. (Only PIN code lockis canceled.)*When PIN code Lock is enabled:PIN code is matched - Command is valid (Acceptable)PIN code is mismatched - Command is invalid (Error code “102”)PIN code is beyond %1 available range - Command is invalid(Error code “?”)When PIN code lock is canceled:PIN code is within %1 range - Command is valid (Acceptable)PIN code is out of %1 range - Command is invalid (Error code is102)This command is only valid when “PJ PIN code” dialog is displayedto enter PIN code after Power is ON and Countdown is completed.When PIN code lock is set to “On1”, it needs to send this commandevery time the projector is turned on.Response Acceptable “000” [CR]Unacceptable8.9.12 CF_FILH CommandCommand“CF_FILH_%1” [CR]“Error Code” [CR]%1 “RST” - Reset Filter used timeDetailReset used time for filter of projectorResponse Acceptable “000” [CR]Unacceptable8.9.13 CF_FILTIMER CommandCommand“CF_FILTIMER_%1” [CR]“Error Code” [CR]%1 “0400” - Set 400 hours“0700” - Set 700 hours“1000” - Set 1000 hours“OFF” - Set Off(Do not warning display)Detail Set time to display Filter cleaning/replacement warning on screen.Response Acceptable “000” [CR]Unacceptable“Error Code” [CR]8-30 LW600-LX900-LX1000 RS232 Codes-Expanded Technical Reference Information020-000046-02 Rev 2 (07-2011)