DNR200V_SERIES_MANUAL_EN_R1_web - Digimerge

Troubleshooting• Hard drive is notdetected by thesystem• Hard drive is fulland the unit is nolonger recording• Mouse not detectedby system• My system does notseem to be recording• Hard drive cables are loose ornot properly connected• Hard drive has not beeninitialized (formatted) by thesystem• There is no hard drive in thesystem• Overwrite is not enabled• Mouse cable is not firmlyconnected to the system• Mouse is not connected to thesystem• System needs to be reset• Recording may be disabled• Remove the housing and check that hard drivecables are firmly connected• For details, see “Formatting the Hard Drive” onpage 106• Open the housing and install a 3.5" SATA harddrive• From the Main Menu, select General. Beside HDDFull, select Overwrite. Click OK to save settings.This enables the system to continuously record byoverwriting data once the hard drive is full• Firmly connect the mouse cable to the system• Re-connect the power cord to restart the system.• Right-click in live view, and click Record. Ensurethat each channel is set to Schedule or Manual. Ifschedule is selected, make sure schedule settingsare correct under Setting>Schedule.ATTENTION: For security, it is highlyrecommended to keep Continuous Recording ON atall times108