DNR200V_SERIES_MANUAL_EN_R1_web - Digimerge

Using the Main Menu5. If the Status indicator is green, the camerais connected and no further configurationis required. Click OK to save changes.6. If the Status indicator is red, click .Update the following information, asneeded.• Manufacturer: Select the manufacturer ofyour IP camera.• User: Enter the camera’s user name.• Password: Enter the camera’s password.• RTSP Port: Enter the camera’s RTSP Port.• HTTP Port: Enter the camera’s HTTP Port.NOTE: See the manufacturer’s user manualfor your IP camera for the default username, password, etc.7. Click OK. Click OK again to save changes.Manual Addthe NVR or is connected to the PoE Ports. Youmay attempt to manually connect IP camerasusing Manual Add.To manually add a camera to the NVR:1. Click Manual Add. Configure the following:• IP Address: Enter the public IP address ofyour IP camera.• Manufacturer: Select the manufacturer ofyour IP camera.• User: Enter the camera’s user name.• Password: Enter the camera’s password.• RTSP Port: Enter the camera’s RTSP Port.• HTTP Port: Enter the camera’s HTTP Port.NOTE: See the manufacturer’s user manualfor your IP camera for the default username, password, etc.2. Click OK. Click OK again to save changes.Editing CamerasIf the Status indicator on cameras connected tothe NVR via PoE or LAN is red or if you changethe connection details for your IP cameras, youwill need to update this information.To edit cameras:1. Click next to the camera you wouldlike to edit.2. Configure the connection information asneeded.3. Click OK. Click OK again to save changes.Deleting Cameras• Click next to the camera you would liketo delete.If the IP address of your IP camera does notappear when you run IP search, ensure thatthe camera is connected to the same LAN as31