REER-Mosaic Manual

MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC
Parameters
There are two types of reset: Manual and Monitored. When Manual is selected the system
only verifies the signal's transition from 0 to 1. If Monitored is selected the double
transition from 0 to 1 and then back to 0 is verified.
t = 250 ms
t1 > 250 ms
t2 = 250 ms
Important: for Manual reset always use the input immediately after those used by the
function block. E.g.: if inputs 1 and 2 are used for the function block, use input 3 for
Reset.
The time that must pass between the
( ).
- 0 ms ÷ 1 s Step 100 ms
- 1.5 s ÷ 10 s Step 0.5 s
- 15 s ÷ 25 s Step 5 s
input reaching and the real guard unlock
Maximum delay accepted between output and input (must be the one shown
on the lock data sheet with appropriate gap decided by the operator).
- 10 ms ÷ 100 s Step 10 ms
- 150 ms ÷ 1 s Step 50 ms
- 1.5 s ÷ 3 s Step 0.5 s
the cycle proceeds.
Only with door opening and subsequent confirmation of input GATE,
If selected, enables configuration without Gate but only with LOCK FEEDBACK
(feedback coil lock).
The guard is locked passively and released actively, i.e. the mechanical force of
the spring keeps it locked. The guard thus continues to be locked even when the power supply is
disconnected.
English
This can be selected to enable a signal (Error Out) to indicate a lock
malfunction. When Error Out = 1 (TRUE) there is a fault in the lock.
116 8540780 • 12/01/2016 • Rev.25