REER-Mosaic Manual

More documents

Recommendations

Info

MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC Standard tool bar The standard tool bar is shown in Figure 37. The meanings of the icons are listed below: Figure 37 (composition of different modules) (name, company, etc) (Real time I/O status - ) (Real time I/O status - ) english 64 8540780 • 12/01/2016 • Rev.25
MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC Textual tool bar Optionally the textual tool bar shown below is also available (drop down). Figure 38 Create a new project (configure the MOSAIC system) Select icon CREATE (Figure 37) from the standard tool bar to start a new project. The user authentication window is displayed (Figure 39). Figure 39 Next the MSD displays a window showing the M1 only. You may add the various units needed to create your system, using the pull-down menus at the top of the screen (select slave) and at the bottom to select the relative node (0÷3). (to add to your configuration) Firmware version (from 0 to 3) Figure 40 Select to disable MCM operations English 8540780 • 12/01/2016 • Rev.25 65
Page 1 and 2:
MODULAR SAFETY INTEGRATED CONTROLLE
Page 3 and 4:
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14: MODULAR SAFETY INTEGRATED CONTROLLE
Page 63: MODULAR SAFETY INTEGRATED CONTROLLE
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143:
show all

REER-Mosaic Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?