UWE Bristol Engineering showcase 2015

James Killick
Beng Robotics (Hons)
Project Supervisor
Matthew Studley
Tattoo Assisting Machine : Analysis and Design
Simulated System
Straight Line Testing:
Initial results with natural solenoid delay:
Prototype Testing system
Outline program testing:
Prototype Testing system
Project summary
The focus of this investigation is to develop a
machine with the aim of assisting tattoo
artists by technologically improving their
accuracy while maintaining the trusting
relationship between the contributing parties.
This is achieved using sensors and image
processing programs and will help to prevent
the artist from drawing outside of the chosen
design.
Results after implementation of “de-bounce function
Complete Simulated system:
Accuracy test(indicated error of 0.5mm
Complete System Testing
Max Error = 0.5mm
Max Error = 0.5mm
Proposed Final Design
Project Objectives
During this project the aim is to develop a functioning
prototype that adheres to the following
requirements.
• Must be able to accurately draw a design onto the
chosen test material.
• Must improve upon the natural skill of the user.
• Must be light and small enough to not hinder the
user.
• Must be safe enough to not endanger the user or
subject.
• Must be able to function at an acceptable speed.
Project Conclusion
In conclusion this investigation has been
viewed as a partial success because under
controlled conditions the prototype system
proved to a significant improvement on the
ability of the user under the same testing
conditions thus indicating the potential for
this system to be used as an artistic aid. With
the addition of some components a more
accurate system would be developed enabling
a more successful result to be achieved.