catalogo-8020_compressed

Floor to Frame
Adjustable Position Floor Lock
Fractional
Metric
Part Description:
The adjustable position floor lock uses a spring-loaded rubber foot pad to immobilize equipment. It is commonly
used to keep frames from shifting and has a foot that can adjust up to 2.75” (69.85mm), allowing greater design
flexibility. The adjustable position floor lock has a foot release lever and commonly mounts to a T-slot profile
side using a position floor lock base plate. There is a minimum weight requirement of 70 pounds (31.75 kg)
necessary to properly immobilize equipment. By adjusting the tension nut, the holding force can be increased
from 70 pounds (31.75 kg) to 120 pounds (54.43 kg). For base plate options see pages 636-637.
A
B
L
(RETRACTED)
C
D
M
(LOAD
HEIGHT)
G
E
F
H
J
K
N
(EXTENDED)
Retracted
Extended
Part No. Series A B C D E F G H J K L M N
Load
Capacity
Weight
2731 4.500” 3.400” 3.000” 2.100” 3.000” 4.750” 5.250” 6.500” .490” .380” 4.500” 5.500” 7.500” 70-120 lb 7.115 lb
40-2731 114.30mm 86.36mm 76.20mm 53.34mm 76.20mm 120.65mm 133.35mm 165.10mm 12.45mm 9.66mm 114.30mm 139.70mm 190.50mm 32-54 kg 3.233 kg
Material Specifications
Material
Finish
Base Plate
Profile
FLOOR TO FRAME
Steel Casting
Paint
Suggested Hardware (Mount to Base Plate)
Part No. Series Qty. Bolt
3289 4 3/8-16 x 1.00” SHCS & Washer
13-1525 4 M10 x 25mm SHCS & Washer
Adjustable Position Floor Lock
Bolt
Washer
610
For the most up to date information on 80/20 ® products visit 8020.net