catalogo-8020_compressed

Machining Services
Edge Radius
Part Description:
Fractional
Metric
The edge radius is used to round off either both or one sharp edge of highly visible panels. When both
edges are rounded the radius will be equal to the panel thickness; when one edge is rounded the radius will
equal to half the panel thickness with a minimum panel thickness of .250” (6.35mm). The edge radius can
also help ease the insertion of panels into gasket. Edge radius services are for all four panel sides. Less
than all four sides requires a drawing designating which sides receive the edge radius service.
Full Edge Radius
Top Edge Radius
Full Edge Radius
MACHINING SERVICES
Panels
Part No.
Aluminum
Part No.
Series Service Type Radius Tolerance
7500 7221 Full Edge Radius Plastic Panel or Aluminum Plate ALL Sides Less Than Or Equal To 48”
7501 7222 Full Edge Radius Plastic Panel or Aluminum Plate ANY Side Greater Than 48”
65-7500 65-7221 Full Edge Radius Plastic Panel or Aluminum Plate ALL Sides Less Than Or Equal To 1220mm
65-7501 65-7222 Full Edge Radius Plastic Panel or Aluminum Plate ANY Side Greater Than 1220mm
*Minimum Panel Thickness is .125” (3.18mm). Maximum Panel Thickness is .500” (12.7mm).
Top Edge Radius
Panels
Part No.
Aluminum
Part No.
+/- .040”
+/- 1.02mm
Series Service Type Radius Tolerance
7540 7542 Top Edge Radius Plastic Panel or Aluminum Plate ALL Sides Less Than Or Equal To 48”
7541 7543 Top Edge Radius Plastic Panel or Aluminum Plate ANY Side Greater Than 48”
65-7540 65-7542 Top Edge Radius Plastic Panel or Aluminum Plate ALL Sides Less Than Or Equal To 1220mm
65-7541 65-7543 Top Edge Radius Plastic Panel or Aluminum Plate ANY Side Greater Than 1220mm
*Minimum Panel Thickness is .125” (3.18mm). Maximum Panel Thickness is .750” (19.05mm).
+/- .040”
+/- 1.02mm
886
For the most up to date information on 80/20 ® products visit 8020.net