catalogo-8020_compressed

Add-On Components
Fractional 10 Series 15 Series Machining
Pressure Manifolds (Continued)
12-Hole Pressure Manifold Feed Plate
The 12-hole pressure manifold feed plate is commonly used when adding a pressurized substance to a T-slot
profile. It has a tapped hole and mounts on the profile end to seal the connection where the pressurized
substance is released. The suggested mounting hardware and gasket are included. The maximum allowable
pressure is 150 psi (1034.21 kPa).
E
D
F
M
C
H
B
J
G
N
A
K
L
Part No. Series Color A B C D E F G
H
(Thread)
J
(Thread)
K
(Thread)
L M N Weight
2449 Clear 1.000” .500” .500” 2.000” .500” 1.000” 2.000” 3/8" NPT 1/4" NPT 1/4 SHCS 1.000” .490” 4.000” .320 lb
2449-Black Black 1.000” .500” .500” 2.000” .500” 1.000” 2.000” 3/8" NPT 1/4" NPT 1/4 SHCS 1.000” .490” 4.000” .320lb
2164 Clear 1.500” .750” .750” 3.000” .750” 1.500” 3.000” 1/2" NPT 3/8" NPT 5/16 SHCS 1.500” .740” 6.000” 1.328 lb
2164-Black Black 1.500” .750” .750” 3.000” .750” 1.500” 3.000” 1/2" NPT 3/8" NPT 5/16 SHCS 1.500” .740” 6.000” 1.328 lb
* Included mounting hardware and material specifications can be seen on page 759
12-Hole Gasket for Pressure Manifold
The 12-hole gasket for pressure manifold is made of a cork and synthetic rubber combination used to prevent
leakage. It is commonly used with manifold plates to completely seal a profile end or create a tight seal where a
substance is released.
Part No. Series Color Material A B C D E F G H J K L M N Weight
2173
1.000” .500” .500” 2.000” .500” 1.000” 2.000” .750” .530” .265” 1.000” .030” 4.000” .006 lb
Brown Velumoid
2144 1.500” .750” .750” 3.000” .750” 1.500” 3.000” 1.250” .750” .275” 1.500” .030” 6.000” .012 lb
ADD-ON COMPONENTS
758
For the most up to date information on 80/20 ® products visit 8020.net
CONTINUE