catalogo-8020_compressed

Machining Services
Fractional
15 Series
Metric 40 Series 45 Series
Miter Connector Profile Milling
Part Description:
The miter connector profile milling service allows a miter connector face to be flush with the profile surface and is
required when using this connector for a profile connection. See page 222 for information on the miter connector.
A
ø .597” x “C” Deep
(15.16mm)
B
ø .394” x “A” Deep
(10.00mm)
E
D
1.439”
(36.55mm)
ANG
1.858”
(47.20mm)
Miter Connector Profile Milling
Bar Cut Angle (0-45): ANG 7.5º 15º 22.5º 30º 45º
MACHINING SERVICES
Compatible Series: ---
ø.394 (10mm) Drill Depth: A 1.957” 49.83mm 50.16mm 2.059” 52.55mm 53.22mm 2.169” 55.48mm 56.51mm 2.291” 58.74mm 60.18mm 2.608” 67.19mm 69.69mm
ø.597 (15.16mm)
C-bore from Miter Tip:
B 1.538” 39.18mm 39.51mm 1.640” 41.91mm 42.58mm 1.750” 44.84mm 45.87mm 1.872” 48.10mm 49.54mm 2.189” 56.55mm 59.05mm
Counterbore Depth: C 1.036” 27.25mm 29.77mm 1.036” 27.25mm 29.77mm 1.036” 27.25mm 29.77mm 1.036” 27.25mm 29.77mm 1.036” 27.25mm 29.77mm
Miter Offset: D .099” 2.63mm 2.96mm .201” 5.36mm 6.03mm .311” 8.28mm 9.32mm .433” 11.55mm 12.99mm .750” 20.00mm 22.50mm
Center of Bar: E .750” 20.00mm 22.50mm .750” 20.00mm 22.50mm .750” 20.00mm 22.50mm .750” 20.00mm 22.50mm .750” 20.00mm 22.50mm
Part No. Series Service Type
7110
40-7110
45-7110
Counterbore for Miter Connector
Miter Connector Machining Designations
876
For the most up to date information on 80/20 ® products visit 8020.net