catalogo-8020_compressed

Quick Frame
Ready Tube
Fractional
Machining Services
45 Degree Flange Milling / Connector Rod End Tap
45 Degree Flange Milling
The 45 degree flange milling service allows two Quick Frame profile flanges to intersect at 90 degrees without
interference. Additional Information: This service is for two ends. If one end is desired specify left or right end.
MITER
.500”
Part No. Series Service Type
7300 45 Degree Flange Milling Service for Quick Frame Location A, B or C only
7301 45 Degree Flange Milling Service for Quick Frame Location A and B
7302 45 Degree Flange Milling Service for Quick Frame Location A and C
Ordering Example: (2) #9010 x 22.00” w/ #7300 on A per drawing.
45 Degree Flange Machining Designations
MACHINING SERVICES
Connector Rod End Tap
The connector rod end tap machining service is used to add threads to the end of a connector rod. This enables
the insertion of a bolt to mount accessories. Additional Information: When ordering this end tap, designate
which end (left, right or both) requires the tap. See page 764 for more information on connector rods.
Tap
Part No. Series Tap Size (Min. Depth) Taps Per End Profile Part No.
7105 5/16-18 (1.25”)
7106 M8 x 1.25” (31.75mm)
1 9820
For the most up to date information on 80/20 ® products visit 8020.net
883