3980xpi Users Manual - Data I/O Corporation

Commands
Edit Parameters
More Commands/Configure System/Edit Parameters
Use the commands on the Edit menu to change system parameters, including
settings for Programming, Serial I/O, Communication, and Interface screens.
Select Edit from the Configure System menu to display the Edit Parameter
menu. Default settings are shown on page 4-3.
The following system parameters can be saved and restored with the More
Commands/Configure System/Save and More Commands/Configure System/
Restore commands.
Serial Port Parameters
Interface Parameters
Baud Rate Power On CRC Mode
Parity Enable Terminal Beeps
Data Bits Remote On Code
Stop Bits Remote Off Code
Enable CTS/DTR Main Menu Job Files
Power Up User RAM Test
Programming Parameters Communication Parameters
Source/Destination Source/destination
Reject Option I/O Translation Format
Logic Verification I/O Addr Offset
Verify Passes I/O Timeout
Verify Data Format Upload Wait
Checksum Calculation Transmit Pacing
Algorithm Type Download Echoing
Data Word Width Output Record Size
User Data Size Number Of Nulls
Memory Begin Address Instrument Control Code
Device Begin Address Fill Memory Option
Device Block Size Fill Data
Illegal Bit Check High Speed Download
High Speed Logic Drivers User Menu Port
Blank Check JEDEC I/O Translate DIP/LCC Vectors
Compare Elec ID Upload: Use End-of-file Delimiter
Enable Yield Tally Upload End-of-file Delimiter
Erase EE Device Download: Use End-of-file Delimiter
Odd/Even Byte Swap Download End-of-file Delimiter
Continuity Check Upload Host Command
Serial Vector Test
Compensated Vector Test
Display Device Footnote
Abort on Empty Socket
RAM Device Selection
Download Host Command
4-20 3980xpi/3980/3900/2900 User Manual