3980xpi Users Manual - Data I/O Corporation

Session 10: Editing Data
Getting Started
In the previous Session, you loaded a data file into the programmer. In this
Session, you will learn how to edit that data file.
1.Return to the Main Menu and select a memory device. (See Session 3.)
2.Select More Commands/Edit Data from the Main Menu, then select Edit
Memory to display the Edit Programmer Memory screen (see Figure 3-17).
Figure 3-17. Edit Programmer Memory Screen
Figure 3-18. Edit Screen
3.Set the parameters as shown in Figure 3-17, then press ENTER. The Edit
screen is displayed (see Figure 3-18).
The edit screen displays 256 bytes at a time. The reminder bar at the
bottom of the screen displays the available commands (no online Help is
available for this screen), the right side of the screen displays the ASCII
translation of the hexadecimal bytes on the left portion of the screen, and
the top line of the screen displays the address location of the cursor (in
hexadecimal) and the addressing mode.
3980xpi/3980/3900/2900 User Manual 3-31