3980xpi Users Manual - Data I/O Corporation
3980xpi Users Manual - Data I/O Corporation
3980xpi Users Manual - Data I/O Corporation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Messages<br />
OPERATION COMPLETE. Sumcheck = hhhhhhhh. Set Sumcheck = ssssssss<br />
The Set Program, Load, or Verify operation is complete. hhhhhhhh is the sumcheck<br />
of data that was just programmed into the last set member. ssssssss is the<br />
sumcheck of all the set members that have been programmed.<br />
Options installed. Hit Return after changing your terminal settings.<br />
This message appears on the Serial Port Configuration screen after you change<br />
serial port parameters and press ENTER. The programmer suspends screen output<br />
until you press ENTER again. Be sure to configure the terminal to match the new<br />
settings for the serial port.<br />
Parameter Entered<br />
The parameter you entered was accepted.<br />
Parameter Field Full. Hit return or arrows to enter, CTRL Z to abort.<br />
You tried to enter too many characters into a parameter field. Press ENTER, F1, or<br />
F2 to enter the parameter.<br />
Partial or no transfer performed. <strong>Data</strong> sum = hhhhhh<br />
Power Down<br />
Pre-format check.<br />
See page 6-19.<br />
The programmer experienced a power down condition.<br />
The programmer is checking to see if the disk you want to format is a System disk.<br />
Go to the self-test screen and re-execute the test(s) that shows status of F (Fail).<br />
If the test(s) fails while the device socket is empty, the programmer may require<br />
service. Contact <strong>Data</strong> I/O Customer Support.<br />
Purging filename.ext<br />
This message is displayed when you are using the wildcard (*) designation to<br />
purge more than one file at once; for example, type 27*.dat to delete both the<br />
files 27512.dat and 27256.dat.<br />
Reading user data file size<br />
The programmer is reading the data file size from disk.<br />
Recording system state parameters.<br />
This message is displayed after you select a file number for a set of system<br />
parameters to be saved. It remains displayed until the programmer is finished<br />
recording the parameters.<br />
Restoring system state variables.<br />
The programmer is reading the recorded system variables from the selected file.<br />
RTC err<br />
The programmer experienced an error it cannot recover from. Turn off the<br />
programmer and reboot the system. If the error recurs, contact <strong>Data</strong> I/O<br />
Customer Support.<br />
6-8 <strong>3980xpi</strong>/3980/3900/2900 User <strong>Manual</strong>
Change language