3980xpi Users Manual - Data I/O Corporation

Session 11: Programming a Memory Device
Load the Data File
Set the Parameters
Getting Started
This Session shows you how to use the programmer to program a memory
device. Before you go through this Session, complete Session 2.
If you do not have an AMD 27256 (the device we are going to use for this
Session), go to the Select Device screen and select the device you are going to
program. The device you select might not have the same capabilities as the
AMD 27256. For example, the AMD 27256 supports Electronic ID while the
Hitachi 27256 does not.
Before you can program the device, you must perform the following steps to
load your data into RAM.
1.Create a binary file on a disk.
2.Insert the disk into the programmer disk drive.
3.From the More Commands/File Operations menu, select the Load File
command to load the data file into RAM. This operation is described in detail
in Session 6.
After the data is loaded in RAM, select Program Device from the Main Menu.
The Program Memory Device screen is displayed (see Figure 3-19).
Figure 3-19. Program Memory Device Screen (Non-default Parameters)
One of the following two Program Memory Device screens is displayed:
� The Non-default Parameters screen (the default screen) displays a
subset of the Program Memory Device parameters supported by the
selected device (see Figure 3-19). Usually these are the only parameters
you need to set.
� The All Parameters screen displays all the Program Memory Device
parameters supported by the selected device (see Figure 3-20). When you
perform more complicated operations, such as programming only part of
the device, you will change some of the parameters on this screen.
3980xpi/3980/3900/2900 User Manual 3-33