3980xpi Users Manual - Data I/O Corporation

Interface Modes
Exiting CRC Mode
Computer Remote Control
6. Move the cursor to the Power on CRC field and press Y. CRC is now
selected. The following steps in this procedure save CRC mode as a
powerup system parameter.
7. Press F2 two times to return to the Configure System Parameters menu.
8. Press S to select Save from the Configure System Parameters menu. The
screen displays the Save System Parameters menu.
9. Type 1 ENTER to select the Powerup Defaults file as the one where system
parameters will be saved.
10. Press ENTER again so that the selection will be saved to the disk. The next
time you power up the programmer, it will enter CRC mode automatically.
You can operate the programmer in one of two interface modes: Terminal
and CRC. In Terminal mode you use screens and menus to interact with the
programmer. In CRC mode you send single-line commands to the programmer
and the programmer responds with single line prompts, responses, and error
codes.
Note: Terminal mode operations may be run from either the
Terminal port or the Remote port. CRC mode operations must be
run from the Remote port; CRC will not work on the Terminal port.
Depending on the equipment you have connected to the programmer, and on
the settings of the User Menu Port and Power-on CRC parameters, you can
select which mode is available on which port. (The User Menu Port parameter
is found on the More Commands/Configure System/Edit/Communication
Parameters screen.)
Factory defaults for the programmer are Terminal mode commands sent
through the Terminal port and CRC mode commands sent through the Remote
port. The factory default for power-up state is Terminal mode.
Press CTRL+Z to exit CRC from an ASCII terminal on the Terminal port.
From a remote computer, send the Z ENTER command. If you exit remote mode
using the Z ENTER command, the programmer's parameters are set to what
they were before you entered remote mode. If you exit using CTRL+Z, the
programmer's parameters are NOT changed.
Suspending CRC Mode
CRC Mode can be suspended temporarily to allow you to go into terminal mode
to view or change parameter settings or the device data in memory. If the
User Menu Port is set to T (Terminal port) press CTRL+Z to suspend CRC Mode.
If you are controlling the programmer from the Remote port, send the 49]
command.
3980xpi/3980/3900/2900 User Manual B-3