3980xpi Users Manual - Data I/O Corporation

6 Messages
Message List
0 div err
Addr err
This chapter describes system and error messages you may see while operating
the programmer. Messages are listed in alphabetical order.
Online Help is also available for messages. If the message you are looking for is
not in this chapter, press F3 or ? when the message appears for a description.
Troubleshooting Guides describing the following messages and associated
corrective actions are included at the end of this chapter:
Device Insertion Error When Using Elastomeric Pad . . . . . . . . . . . . . . . . . . 6-11
Device Overcurrent Fault . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-13
Device Programming Error . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-14
Invalid Device ID on Logic Device . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-15
Electronic ID Verify Error on Memory Device . . . . . . . . . . . . . . . . . . . . . . . 6-16
Illegal Bit Error. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-17
I/O Timeout Error . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-18
Partial or No Transfer Performed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-19
Incompatible User Data File for Device Selected . . . . . . . . . . . . . . . . . . . . . 6-20
The programmer experienced a divide-by-zero error that it cannot recover from.
Turn off the programmer and reboot the system. If the error recurs, contact
Data I/O Customer Support.
The programmer has experienced an error that it cannot recover from. Turn off the
programmer off and reboot the system.
Address out of range
The address you tried to select is beyond the selected device's range. Select an
address that is within the limits of the device or select a different device. This
message appears while you are in the memory editor, fuse editor, or using the
under/overblow feature.
Altera POF translator must be selected for POF devices
You selected an Altera POF device and tried to run a data transfer operation, such
as a download, but you did select the POF data translation format. Select the POF
Format as the data translation format, and retry the operation.
ASCII entry not allowed in 4-bit mode
This message appears in the memory editor when the programmer tries to go into
ASCII entry mode when a 4-bit device is selected. Reselect the device or edit in
hex mode only.
3980xpi/3980/3900/2900 User Manual 6-1