3980xpi Users Manual - Data I/O Corporation

2. Insert Boot Disk in Programmer
Setting Up
Insert the Boot Disk into the programmer disk drive as described below.
1. Make sure both the Boot disk and the Algorithm/System disk are write
enabled (see Figure 2-2).
Figure 2-2. Write-enabled Disk
BACK OF DISK
2. Insert the Boot Disk into the programmer disk drive (see Figure 2-3) so
that the arrow molded into the plastic case is on the top of the disk and
points toward the programmer. Push the disk straight into the drive until
the disk drops down and the eject button pops out.
Figure 2-3. Inserting the Boot Disk (2900/3900)
1.44MB DISK DRIVE
MOLDED ARROW
WRITE-PROTECT TAB
WRITE ENABLED
POSITION
BOOT DISK
EJECT BUTTON
3980xpi/3980/3900/2900 User Manual 2-11
1374-3
0530-5