3980xpi Users Manual - Data I/O Corporation

Getting Started
To switch between the two screens, press F4. For this Session you will be using
the Non-default screen.
Figure 3-11. Load Memory Screen (All Parameters)
Load the Data
Review
Set the parameters as shown in Figure 3-10. To change the value of a
parameter, move the cursor to the desired field, type the new value, then
either press ENTER or use the arrow keys to move the cursor to a new field.
If you try to enter an incorrect parameter, the programmer beeps and the
message line reads Illegal parameter value. If you enter a valid
parameter, the message line reads Parameter Entered.
For more information on a parameter, see Chapter 4 or use online Help.
Now that you have set the parameters, you can load the data from the device.
To begin the load, press ENTER. When the programmer has loaded the data, it
displays: OPERATION COMPLETE: Sumcheck = xxxxxxxx, where
xxxxxxxx represents the 8-digit sumcheck of the data loaded from the
device. (A 4-digit sumcheck is displayed for a logic device.)
When you select Load Device from the Main Menu, you see either the Nondefault
screen or the All Parameters screen. Press F4 to toggle between the
two.
Set the parameters, then press ENTER to begin the Load operation.
When the programmer is finished loading the data from the device, it displays
the sumcheck.
3-22 3980xpi/3980/3900/2900 User Manual