3980xpi Users Manual - Data I/O Corporation

Commands
5. Select a file number for the newly created job file. For example, to make
this job file number five on the Job Files screen, press 5 ENTER. If you select
a file number already in use, the programmer prompts you to press ENTER
to overwrite the existing file. To preserve the existing file, press CTRL+Z.
6. Move the cursor down to the Enter Description field and type a name for
the job file that was just recorded. The description can be up to 31
characters long and should be followed by ENTER.
To save the job file, press ENTER. While the file is being saved, the action
symbol rotates. When the save action is done, you are returned to the last
screen displayed during job file recording.
If you do not want to save the job file, press F2 or F1.
Playing Back a Job File
Remote Control
More Commands/Job File
Use the Job File command to play back a pre-recorded job file. To play back a
job file, follow these steps:
1. Go to the Job Files screen.
2. You see a listing of the job files stored on the Algorithm/System disk in the
disk drive. To select a job file from this disk, type the number of the job file
you want to play back and press ENTER. For example, to play back the fifth
file on the list, press 5 ENTER.
To view a list of job files stored on another disk, insert the disk and press
F4, which reconstructs the job file directory.
3. The programmer now plays back the keystrokes that were recorded. Each
screen displayed while you were recording keystrokes is shown (briefly).
4. After the job file is played back, the programmer displays the following
message: Job file playback ended.
The last screen recorded while you were creating the job file is now
displayed. If an error occurred during playback, an error message is
displayed and the job file must be re-recorded.
More Commands/Remote Control/CRC Mode
This command puts the programmer in Computer Remote Control mode. To
exit remote control, type CTRL+Z on the terminal's keyboard, or send a Z ENTER
command from the host computer.
Chapter 2, Setting Up, describes how to set up your system. Appendix B,
Computer Remote Control, provides information on how to use CRC and
describes the CRC command set.
3980xpi/3980/3900/2900 User Manual 4-59