3980xpi Users Manual - Data I/O Corporation

Messages
Trc init err
The programmer experienced an error it cannot recover from. Turn off the
programmer and reboot the system. If the error recurs, contact Data I/O Customer
Support.
User RAM sumcheck = ssssssss
This message contains the sumcheck for all of User RAM and is generated in the
Sumcheck device check screen. This calculation is done regardless of whether user
data are in RAM or on disk.
Using Keep Current algorithm in filename.KCx
This message appears when the replaced Keep Current algorithm is used during a
normal device selection operation where filename.KCx is the Keep Current
algorithm file.
Vector out of range
The vector you tried to select does not exist for the selected device. Select a vector
that is within the limits of the device, or select a different device. This message
may appear while you are using the vector editor.
Waiting for self-test completion.
This powerup message shows up only if you are changing the terminal selection
before the power-up self-test has been completed.
WARNING: System disk in drive. Hit return to continue, ^Z to abort.
This message appears during any file operation that displaces disk data. Any
information currently on the disk will be erased and is not retrievable. Press ENTER
continue with the operation. Press CTRL+Z to cancel the operation.
6-10 3980xpi/3980/3900/2900 User Manual