Press Matcher Web User Manual - image2output - Support

EFI Fiery RIP
Set up ORIS Press Matcher⁄⁄Web Queue
http://www.image2output.com
// WEB«
6. Select the iterative color matching method to create a new
ORIS_DAT color table.
7. Having printed the first color matching test chart, inspect the print settings
to see whether they are correct (see page 6-6). Owing to deficiencies
in the Fiery software, some of these settings may not persist.
To do so, start Command WorkStation, click on JOB CENTER, locate
the print job in the list named HELD, then double-click the print job.
If important options are set incorrectly (e.g. a CMYK simulation profile
is selected), disable bidirectional communication and repeat the color
matching process. Refer to page 6-21 for more details.
8. Finish the queue setup in ORIS Press Matcher⁄⁄Web.
9. Having printed the first color-matched job via the new ORIS Press
Matcher⁄⁄Web queue, you should verify the print settings in Command
WorkStation again (see above).
If there are Fiery print settings that differ from those made in Command
WorkStation, disable bidirectional communication and repeat
the color matching process. Refer to page 6-21 for more details.
6-20 CGS Hainburg, Germany 06/17/2011
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com