Press Matcher Web User Manual - image2output - Support

WEB«
http://www.image2output.com
6. Click SAVE to save the density data to a file (*.DEN).
Recalibration
Recalibration Process
We recommend to save the file under …\Program Files\CGS\Common
Files\CTuner Setups\\\LIN\. This is usually the
default save location.
7. Click OK to close the LINEARIZATION BY DENSITIES dialog. A linearization
file (*.LIN) will be created.
We recommend to save the file to the same directory as the *.DEN file
(default). The default file name is _.LIN.
See also Reference Printer Profile (RFP File) (page 16-11).
Step 2: Iterative Printer Calibration
The Recalibration Wizard will guide you through the following steps:
1. Print the calibration test chart.
2. Measure the printed test chart.
Save the measurement file under …\Program Files\CGS\Common
Files\CTuner Setups\\\Measurement\. This is
usually the default save location when using a measurement device
connected to the computer.
3. Optimize the calibration file, if required.
Repeat the calibration process until a substantial reduction of color
deviations is no longer achieved. Usually three iterations are required
to achieve an average delta E < 0.8 and a maximum delta E < 5.
Fig. 19-4 Recalibration Wizard – Evaluation
ORIS Press Matcher⁄⁄Web Version 1.1 Advanced User’s Manual 19-5
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com