Press Matcher Web User Manual - image2output - Support
Press Matcher Web User Manual - image2output - Support
Press Matcher Web User Manual - image2output - Support
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
EFI Fiery RIP<br />
Create a Virtual Printer?<br />
Create a Virtual Printer?<br />
http://www.<strong>image2output</strong>.com<br />
// WEB«<br />
Fiery’s driver settings have to be adjusted to the requirements of ORIS<br />
<strong>Press</strong> <strong>Matcher</strong>⁄⁄<strong>Web</strong>. Most important is to completely switch off any color<br />
management, because this will be done by ORIS <strong>Press</strong> <strong>Matcher</strong>⁄⁄<strong>Web</strong>.<br />
There are two general approaches.<br />
Virtual Printer<br />
Create a virtual Fiery printer, i.e. an additional Fiery print queue, and<br />
adjust the color setup of this virtual printer (see below).<br />
This is the recommended method, above all if only some of Fiery’s print<br />
jobs originate from ORIS <strong>Press</strong> <strong>Matcher</strong>⁄⁄<strong>Web</strong> and many from other<br />
applications. Usually it is not acceptable to switch off color management<br />
for print jobs from other applications.<br />
However, virtual printers may not always work as expected. Sometimes<br />
driver settings do not persist, i.e. they change by themselves owing to<br />
problems of the Fiery software. Should this occur, using Fiery’s default<br />
print queues may be a possible workaround.<br />
Default Print Queue<br />
Change the default color setup of the Fiery print server. This applies to<br />
Fiery’s default print queues Hold, Print and Direct (see page 6-7).<br />
Use this approach only if all of the print jobs originate from ORIS <strong>Press</strong><br />
<strong>Matcher</strong>⁄⁄<strong>Web</strong> or if the Fiery print server does not support virtual printers.<br />
If a default print queue is used, there are usually no problems with driver<br />
settings that do not persist, though this may also occur sporadically.<br />
The default print queues apply to all print jobs processed by the Fiery<br />
print server. Jobs that were not created by ORIS <strong>Press</strong> <strong>Matcher</strong>⁄⁄<strong>Web</strong><br />
are likely to be printed incorrectly, because no CMYK simulation<br />
profile is applied.<br />
How to Create a Virtual Printer<br />
1. In Command WorkStation, connect to the Fiery print server (see<br />
page 6-1).<br />
2. Select DEVICE CENTER | WORKFLOWS or GO | VIRTUAL PRINTERS.<br />
3. By default, three virtual printers are already set up to correspond to<br />
the Print, Hold, and Direct queues.<br />
Select one of these printers (we recommend Hold) and click DUPLI-<br />
CATE. Alternatively, click the NEW button.<br />
6-4 CGS Hainburg, Germany 06/17/2011<br />
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW<br />
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@<strong>image2output</strong>.com