ssw03_plus_series

Recommendations

Info

9 APPENDIX NOTE! Contactor "K1" is necessary to protect the motor in case there is a phase failure which is caused by damage in the SSW-03 Plus power circuit with the application of the power isolation contactor. For motor connection, see Item 6.4.1. 113 Downloaded from www.Manualslib.com manuals search engine
9 APPENDIX 9.10 -RECOMMENDED DRIVE WITH CONTROL BY THREE-WIRE DIGITAL INPUTS, WITH BY-PASS CONTACTOR AND CONNECTION WITHIN THE MOTOR DELTA CONNECTION OF THE MOTOR WITH 6 CABLES optional PLUS RED BLACK BLACK RED START STOP EXTERNAL ERROR EMERGENCY OPTIONAL Parameter P28 P43 Programming ON ON P52 1 P53 4 P54 2 P55 3 P61 OFF Obs.: It's necessary to use normal fuses or breaker to protect the installation. Ultra-Fast fuses are not necessary for the SSW-03 Plus operation, but they are recommended for SCR protection. The transformer "T" is optional and must be utilized when the line voltage is different than the electronics and fan voltage. For the integral motor protection it's recommended to install one or more thermostats in the motor. If the thermostat is not used, the external input error (DI3) from SSW-03 Plus must be connected to +Vdc. NOTE! A contactor in the mains input (see 9.4) is necessary to protect the motor in case there is a phase failure which is caused by damage in the SSW-03 Plus power circuit. 114 To maintain motor thermal protection after the Soft-Starter is by-passed, the Current Transformers (CT) must be connected in conformity with the diagram above. For motor connection, see Item 6.4.1. Downloaded from www.Manualslib.com manuals search engine
Page 1 and 2:
Soft-Starter Arrancador Suave Chave
Page 3 and 4:
ATTENTION! Please check which type
Page 5 and 6:
SUMMARY 4.3 Commissioning .........
Page 7 and 8:
SUMMARY 9 APPENDIX 10 OPTINAL DEVIC
Page 9 and 10:
QUICK PARAMETER REFERENCES, ERROR M
Page 11 and 12:
QUICK PARAMETER REFERENCES, ERROR M
Page 13 and 14:
1 SAFETY NOTICE Personnel must revi
Page 15 and 16:
2 INTRODUCTION 2.3 - ABBREVIATIONS
Page 17 and 18:
2 INTRODUCTION 2.4.2 - Simplified B
Page 19 and 20:
2 INTRODUCTION 2.5 - PRODUCT IDENTI
Page 21 and 22:
3 INSTALLATION 3.1.2 - Location / M
Page 23 and 24:
3 INSTALLATION 3.1.3 - Kit IP20 The
Page 25 and 26:
3 INSTALLATION 3.1.4 - Connections
Page 27 and 28:
3 INSTALLATION Figure 3.4 - Power a
Page 29 and 30:
3 INSTALLATION Table 3.1- Recommend
Page 31 and 32:
3 INSTALLATION Copper cables with P
Page 33 and 34:
3 INSTALLATION 3.2.2 - Location of
Page 35 and 36:
3 INSTALLATION When installing the
Page 37 and 38:
3 INSTALLATION of maintenance the i
Page 39 and 40:
3 INSTALLATION The isolation contac
Page 41 and 42:
3 INSTALLATION 3.3 - INSTALLATION O
Page 43 and 44:
4 POWER-UP/COMMISSIONING This Secti
Page 45 and 46:
4 POWER-UP/COMMISSIONING 4.3.1 - Pr
Page 47 and 48:
4 POWER-UP/COMMISSIONING ACTION RES
Page 49 and 50:
5 USE OF THE HMI This Section descr
Page 51 and 52:
5 USE OF THE HMI 5.2.2 - Signalling
Page 53 and 54:
5 USE OF THE HMI P97 - Second hardw
Page 55 and 56:
5 USE OF THE HMI 5.3.1 - Selection/
Page 57 and 58:
6 DETAILED PARAMETER DESCRIPTION Th
Page 59 and 60:
6 DETAILED PARAMETER DESCRIPTION 6.
Page 61 and 62:
6 DETAILED PARAMETER DESCRIPTION t
Page 63 and 64: 6 DETAILED PARAMETER DESCRIPTION 6.
Page 65 and 66: 6 DETAILED PARAMETER DESCRIPTION 2)
Page 67 and 68: 6 DETAILED PARAMETER DESCRIPTION Fa
Page 69 and 70: 6 DETAILED PARAMETER DESCRIPTION Op
Page 71 and 72: 6 DETAILED PARAMETER DESCRIPTION P0
Page 73 and 74: 6 DETAILED PARAMETER DESCRIPTION R
Page 75 and 76: 6 DETAILED PARAMETER DESCRIPTION Fa
Page 79 and 80: 6 DETAILED PARAMETER DESCRIPTION Fi
Page 83 and 84: 6 DETAILED PARAMETER DESCRIPTION an
Page 87 and 88: 6 DETAILED PARAMETER DESCRIPTION Th
Page 89 and 90: 6 DETAILED PARAMETER DESCRIPTION EX
Page 93 and 94: 7 MAINTENANCE Solution: Connect a t
Page 95 and 96: 7 MAINTENANCE Table 7.3 - Periodica
Page 97 and 98: 7 MAINTENANCE 7.2.1 - CLEANING IN-
Page 99 and 100: 7 MAINTENANCE Name Item N 0 Types (
Page 101 and 102: 8 TECHNICAL CHARACTERISTICS 8.2.3 T
Page 103 and 104: 8 TECHNICAL CHARACTERISTICS Human M
Page 105 and 106: 9 APPENDIX 9.1.2.2 Low Voltage Dire
Page 107 and 108: 9 APPENDIX 9.3 - RECOMMENDED APPLIC
Page 113: 9 APPENDIX 9.9 - RECOMMENDED APPLIC
Page 117 and 118: 9 APPENDIX For the integral motor p
Page 119 and 120: 9 APPENDIX Fuse Thyristor/SCR Poten
Page 121 and 122: 10 OPTINAL DEVICES 10.1 - RECOMMEND
show all

ssw03_plus_series

Create successful ePaper yourself

Delete template?

Save as template?