ssw03_plus_series

6
DETAILED PARAMETER DESCRIPTION
min. Range max.
shortest step
Factory
Standard
P57 - Analog Output (8 bits) Gain 0.00 0.01 9.99 1.00
6.4.13 - P61 - Control
enabling
Table 6.1 - Command that depend on the P61 adjust
P61 = OFF P61 = ON
Comands
Digital Input HMI Serial
Description
I/O X X X Digital Input or HMI/Serial
JOG Function X X Digital input 4 (DI4) or Serial
Direction of
rotation
General Enabling
X
X
X
X
Digital input 3 (DI3) or Serial
Digital inputs 2, 3, 4 or serial
• I/O (Start/Stop): When P61 = OFF, it enables via digital inputs
(DI1 or DI1 and DI2) the motor start/
stop.
When P61 = ON, it enables the motor start/
stop via HMI-3P and serial.
When P61 = ON, the digital input "DI1" is
without function.
NOTE!
To make the selection through HMI-3P/serial or digital input,
the motor must be locked, inclusive when the change is HMI-
3P/serial to digital input (DI1), it must be open. If the digital
input (DI1) is closed, the parametrization cannot be processed
and the display flashes.
• JOG Function: This function can be programmed at the Digital
Input (DI4) if P61=OFF; or P61=ON it
operates via serial input.
• Function of the change of the Direction of Rotation:
This function can be programmed at the Digital
Input (DI3) if P61=OFF, or P61=ON it
operates via serial.
• General Enabling: This function can be used as "Emergency
Stop" and it can be programmed for any of
the following Digital Inputs DI2, DI3 or DI4
81
Downloaded from www.Manualslib.com manuals search engine