ssw03_plus_series
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
5<br />
USE OF THE HMI<br />
READING<br />
SELECT/DISPLAY<br />
DESIRED<br />
PARAMETER<br />
CHANGING/<br />
READ<br />
'?'<br />
CHANGING<br />
SELECT P00<br />
ADJUST P00 = ON<br />
PERMIT THE ACCESS<br />
TO CHANGE THE<br />
PARAMETERS *3<br />
PARAMETER<br />
NEEDS STOPPED<br />
MOTOR FOR<br />
ADJUSTMENT<br />
'?'<br />
NO<br />
YES<br />
DISABLE<br />
THE MOTOR<br />
SELECT/SET<br />
DESIRED<br />
PARAMETER<br />
PRESS KEY<br />
Figure 5.2 - Flowchart for read/changing of parameters<br />
*1 The parameters which can be changed with a running<br />
motor, the Soft-Starter begins to use the new set value<br />
immediately, after pressing key .<br />
The parameter, which can be changed with stopped<br />
motor only, the motor must be disabled, now set the<br />
new parameters and press the key .<br />
NOTE!<br />
If it is not possible to change a parameter with running motor,<br />
the display will indicate the parameter content by flashing.<br />
*2 By pressing the key after the adjustment, the last<br />
adjusted value will be stored automatically and this<br />
value will remain stored untill new changes are made.<br />
*3 The disabling of the parameter changing access is made<br />
by setting P00 at "OFF" or de-energizing/energizing the<br />
Soft-Starter electronics.<br />
55<br />
Downloaded from www.Manualslib.com manuals search engine
Change language