ssw03_plus_series

Recommendations

Info

9 APPENDIX 9.11 - RECOMMENDED APPLICATION WITH TERMINALS FOR THREE WIRE CONTROL FOR SEVERAL MOTORS OPTIONAL EMERGENCY PLUS STOP START Obs.: It's necessary to use normal fuses or breaker to protect the installation. Ultra-Fast fuses are not necessary for the SSW-03 operation, but they are recommended for SCR protection. The transformer "T" is optional and must be utilized when the line voltage is different than the electronics and fan voltage. 115 Downloaded from www.Manualslib.com manuals search engine
9 APPENDIX For the integral motor protection it's recommended to install one or more thermostats in the motor. If the thermostat is not used, the external input error (DI3) from SSW-03 Plus must be connected to +Vdc. Motor fuses are normal. Install one overload relay to each motor. The Soft-Starter must be selected for a complete start cycle. 116 Downloaded from www.Manualslib.com manuals search engine
Page 1 and 2:
Soft-Starter Arrancador Suave Chave
Page 3 and 4:
ATTENTION! Please check which type
Page 5 and 6:
SUMMARY 4.3 Commissioning .........
Page 7 and 8:
SUMMARY 9 APPENDIX 10 OPTINAL DEVIC
Page 9 and 10:
QUICK PARAMETER REFERENCES, ERROR M
Page 11 and 12:
QUICK PARAMETER REFERENCES, ERROR M
Page 13 and 14:
1 SAFETY NOTICE Personnel must revi
Page 15 and 16:
2 INTRODUCTION 2.3 - ABBREVIATIONS
Page 17 and 18:
2 INTRODUCTION 2.4.2 - Simplified B
Page 19 and 20:
2 INTRODUCTION 2.5 - PRODUCT IDENTI
Page 21 and 22:
3 INSTALLATION 3.1.2 - Location / M
Page 23 and 24:
3 INSTALLATION 3.1.3 - Kit IP20 The
Page 25 and 26:
3 INSTALLATION 3.1.4 - Connections
Page 27 and 28:
3 INSTALLATION Figure 3.4 - Power a
Page 29 and 30:
3 INSTALLATION Table 3.1- Recommend
Page 31 and 32:
3 INSTALLATION Copper cables with P
Page 33 and 34:
3 INSTALLATION 3.2.2 - Location of
Page 35 and 36:
3 INSTALLATION When installing the
Page 37 and 38:
3 INSTALLATION of maintenance the i
Page 39 and 40:
3 INSTALLATION The isolation contac
Page 41 and 42:
3 INSTALLATION 3.3 - INSTALLATION O
Page 43 and 44:
4 POWER-UP/COMMISSIONING This Secti
Page 45 and 46:
4 POWER-UP/COMMISSIONING 4.3.1 - Pr
Page 47 and 48:
4 POWER-UP/COMMISSIONING ACTION RES
Page 49 and 50:
5 USE OF THE HMI This Section descr
Page 51 and 52:
5 USE OF THE HMI 5.2.2 - Signalling
Page 53 and 54:
5 USE OF THE HMI P97 - Second hardw
Page 55 and 56:
5 USE OF THE HMI 5.3.1 - Selection/
Page 57 and 58:
6 DETAILED PARAMETER DESCRIPTION Th
Page 59 and 60:
6 DETAILED PARAMETER DESCRIPTION 6.
Page 61 and 62:
6 DETAILED PARAMETER DESCRIPTION t
Page 63 and 64:
6 DETAILED PARAMETER DESCRIPTION 6.
Page 65 and 66: 6 DETAILED PARAMETER DESCRIPTION 2)
Page 67 and 68: 6 DETAILED PARAMETER DESCRIPTION Fa
Page 69 and 70: 6 DETAILED PARAMETER DESCRIPTION Op
Page 71 and 72: 6 DETAILED PARAMETER DESCRIPTION P0
Page 73 and 74: 6 DETAILED PARAMETER DESCRIPTION R
Page 75 and 76: 6 DETAILED PARAMETER DESCRIPTION Fa
Page 77 and 78: 6 DETAILED PARAMETER DESCRIPTION 6.
Page 79 and 80: 6 DETAILED PARAMETER DESCRIPTION Fi
Page 83 and 84: 6 DETAILED PARAMETER DESCRIPTION an
Page 87 and 88: 6 DETAILED PARAMETER DESCRIPTION Th
Page 89 and 90: 6 DETAILED PARAMETER DESCRIPTION EX
Page 91 and 92: 6 DETAILED PARAMETER DESCRIPTION 6.
Page 93 and 94: 7 MAINTENANCE Solution: Connect a t
Page 95 and 96: 7 MAINTENANCE Table 7.3 - Periodica
Page 97 and 98: 7 MAINTENANCE 7.2.1 - CLEANING IN-
Page 99 and 100: 7 MAINTENANCE Name Item N 0 Types (
Page 101 and 102: 8 TECHNICAL CHARACTERISTICS 8.2.3 T
Page 103 and 104: 8 TECHNICAL CHARACTERISTICS Human M
Page 105 and 106: 9 APPENDIX 9.1.2.2 Low Voltage Dire
Page 107 and 108: 9 APPENDIX 9.3 - RECOMMENDED APPLIC
Page 115: 9 APPENDIX 9.10 -RECOMMENDED DRIVE
Page 119 and 120: 9 APPENDIX Fuse Thyristor/SCR Poten
Page 121 and 122: 10 OPTINAL DEVICES 10.1 - RECOMMEND
show all

ssw03_plus_series

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?