ssw03_plus_series

Recommendations

Info

9 APPENDIX Reversible switch Transformer Normally closed pushbutton Normally open pushbutton Delay time contact 119 Downloaded from www.Manualslib.com manuals search engine
10 OPTINAL DEVICES 10.1 - RECOMMENDED DRIVE WITH CONTROL BY DIGITAL INPUTS WITH THREE WIRES AND BYPASS CONTACTOR + MAC-0X. Type SSW-03 Plus 120A 170A 205A 255A 290A 340A Item Weg MAC-01 417112127 OPTIONAL 410A 670A 800A MAC-02 417112128 MAC-03 417112129 MAC-0X RED BLACK RED BLACK START STOP EXT. ERROR PLUS EMERGENCY OPTIONAL Regarding the use of the Current Acquisition Module (MAC-0x). This optional device must be used to maintain the motor protections when the SSW-03 Plus is used with bypass contactor. To maintain the protections proceed as follows: 1. Remove the cables of the secondary winding of the SSW-03 Plus current transformer from the connectors X3:3, X3:4 and X3:5 of the CCS3.0x board. These cables must be short-circuited in order to avoid damage of the current transformers incorporated in the SSW-03. Use the connector, wich is delivered with the MAC-0x. One end of this connector has already a jumper that connects the two contacts and the other end must be connected to the cables removed from X3:3, X3:4 and X3:5. 2. Loose the thermostat cables that are connected to the X3:1 and X3:2 connector and connect the two free ends of the plug-in connector that is delivered with the MAC-0x. 3. Connect this connector supplied with the MAC-0x to the control board (CCS3.0x) in the place intended for the X3 connector. 4. Make the power connector as shown up. 120 Downloaded from www.Manualslib.com manuals search engine
Page 1 and 2:
Soft-Starter Arrancador Suave Chave
Page 3 and 4:
ATTENTION! Please check which type
Page 5 and 6:
SUMMARY 4.3 Commissioning .........
Page 7 and 8:
SUMMARY 9 APPENDIX 10 OPTINAL DEVIC
Page 9 and 10:
QUICK PARAMETER REFERENCES, ERROR M
Page 11 and 12:
QUICK PARAMETER REFERENCES, ERROR M
Page 13 and 14:
1 SAFETY NOTICE Personnel must revi
Page 15 and 16:
2 INTRODUCTION 2.3 - ABBREVIATIONS
Page 17 and 18:
2 INTRODUCTION 2.4.2 - Simplified B
Page 19 and 20:
2 INTRODUCTION 2.5 - PRODUCT IDENTI
Page 21 and 22:
3 INSTALLATION 3.1.2 - Location / M
Page 23 and 24:
3 INSTALLATION 3.1.3 - Kit IP20 The
Page 25 and 26:
3 INSTALLATION 3.1.4 - Connections
Page 27 and 28:
3 INSTALLATION Figure 3.4 - Power a
Page 29 and 30:
3 INSTALLATION Table 3.1- Recommend
Page 31 and 32:
3 INSTALLATION Copper cables with P
Page 33 and 34:
3 INSTALLATION 3.2.2 - Location of
Page 35 and 36:
3 INSTALLATION When installing the
Page 37 and 38:
3 INSTALLATION of maintenance the i
Page 39 and 40:
3 INSTALLATION The isolation contac
Page 41 and 42:
3 INSTALLATION 3.3 - INSTALLATION O
Page 43 and 44:
4 POWER-UP/COMMISSIONING This Secti
Page 45 and 46:
4 POWER-UP/COMMISSIONING 4.3.1 - Pr
Page 47 and 48:
4 POWER-UP/COMMISSIONING ACTION RES
Page 49 and 50:
5 USE OF THE HMI This Section descr
Page 51 and 52:
5 USE OF THE HMI 5.2.2 - Signalling
Page 53 and 54:
5 USE OF THE HMI P97 - Second hardw
Page 55 and 56:
5 USE OF THE HMI 5.3.1 - Selection/
Page 57 and 58:
6 DETAILED PARAMETER DESCRIPTION Th
Page 59 and 60:
6 DETAILED PARAMETER DESCRIPTION 6.
Page 61 and 62:
6 DETAILED PARAMETER DESCRIPTION t
Page 63 and 64:
6 DETAILED PARAMETER DESCRIPTION 6.
Page 65 and 66:
6 DETAILED PARAMETER DESCRIPTION 2)
Page 67 and 68:
6 DETAILED PARAMETER DESCRIPTION Fa
Page 69 and 70: 6 DETAILED PARAMETER DESCRIPTION Op
Page 71 and 72: 6 DETAILED PARAMETER DESCRIPTION P0
Page 73 and 74: 6 DETAILED PARAMETER DESCRIPTION R
Page 75 and 76: 6 DETAILED PARAMETER DESCRIPTION Fa
Page 77 and 78: 6 DETAILED PARAMETER DESCRIPTION 6.
Page 79 and 80: 6 DETAILED PARAMETER DESCRIPTION Fi
Page 83 and 84: 6 DETAILED PARAMETER DESCRIPTION an
Page 87 and 88: 6 DETAILED PARAMETER DESCRIPTION Th
Page 89 and 90: 6 DETAILED PARAMETER DESCRIPTION EX
Page 91 and 92: 6 DETAILED PARAMETER DESCRIPTION 6.
Page 93 and 94: 7 MAINTENANCE Solution: Connect a t
Page 95 and 96: 7 MAINTENANCE Table 7.3 - Periodica
Page 97 and 98: 7 MAINTENANCE 7.2.1 - CLEANING IN-
Page 99 and 100: 7 MAINTENANCE Name Item N 0 Types (
Page 101 and 102: 8 TECHNICAL CHARACTERISTICS 8.2.3 T
Page 103 and 104: 8 TECHNICAL CHARACTERISTICS Human M
Page 105 and 106: 9 APPENDIX 9.1.2.2 Low Voltage Dire
Page 107 and 108: 9 APPENDIX 9.3 - RECOMMENDED APPLIC
Page 115 and 116: 9 APPENDIX 9.10 -RECOMMENDED DRIVE
Page 117 and 118: 9 APPENDIX For the integral motor p
Page 119: 9 APPENDIX Fuse Thyristor/SCR Poten
show all

ssw03_plus_series

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?