Sound Processor

More documents

Recommendations

Info

Proel Sound Processors User Manual Proel dualcomp – Quick Start Guide dualcomp is a two-band dynamic processor supplied with 16 factory preset and 16 user presets. This unit can be connected to a PC by RS232, USB, and MIDI ports. It’s possible to connect the dualcomp to any insert point jack of your mixer, according to your application and result you need. For single channel processing (for example a microphone channel) you can insert the dualcomp to that mixer channel. For these insert connections you will need a particular “Y” shaped cable (see hook-up details at page 74 – Appendix 4), which you can easily find in musical instruments and electronic shops. suggested cable PROEL SG210LU3. Please connect a TRS (stereo) ¼” (6.3mm.) plug in your mixer insert, then connect the mono ¼” (6.3mm.) plug corresponding to TRS tip to dualcomp input A, and the ¼” (6.3mm.) plug corresponding to TRS ring to dualcomp output A (see figure 1, page 72). Adjust all the knobs at their minimum position and turn on the unit. Then adjust the knobs as suggested in the following figure: If you’re already feeding the unit with an input signal, you should see LCD display as in the following example. Output Compressor G Reduction: || The above screen shows signal reduction (vu-meter movements toward left side) or expansion (vumeter movements toward right side) achieved by the compressor for channels A+B. It’s possible to select other metering screens pressing the “QUIT” button. 34
Proel Sound Processors User Manual Gain reduction Cmp B Low: || High: || The above screen shows channel B compressors metering. Pressing again the “QUIT” button the display will show channel A compressors screen, similar to the above one. Pressing again the “QUIT” button the display will show the input level screen. Input Level A: B: From this metering screen of both channels, it’s possible to return to the main menu by pressing the “ENTER” button or rotating the “” encoder. Preset xx: Name preset Load Preset On the lower row it’s possible to scroll, using the “” encoder, the following menu items. - LOAD PRESET - SAVE PRESET - UTILITY FUNCTION - EDIT PARAMETERS To select one of these items, please press again the “” encoder. To access to the selected submenu press the “ENTER” button, and to exit from the sub-menu press the “QUIT” button. “ENTER” and “QUIT” buttons can also be used to confirm or to cancel settings. 35
Page 1 and 2:
Sound Processor REMOTE CONTROL SOFT
Page 3 and 4:
Proel Sound Processors User Manual
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62: Proel Sound Processors User Manual
Page 79 and 80: Sound Processor REMOTE CONTROL SOFT
Page 111: Proel Sound Processors User Manual
show all

Sound Processor

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?