Sound Processor

Proel Sound Processors User Manual
Using the “VARIATION” knob you can select the desired value for the selected field.
Delay menu
Using this sub-menu you can select the delay line expressed in meters (from 0 m up to 65.995m, 7
millimetres steps) or in seconds (from 0 ms up to 199.987 ms, 21 microseconds steps).
Choosing meters as delay measurement unit, the display will show.
A
Delay
Using the ““ encoder it’s possible to select hundreds, tens, units and decimals. The selected
digit will flash, showing you can edit it. Using the “VARIATION” knob you can select the desired
value for the selected field.
Mute menu
Using this function you can activate and deactivate the mute function for the selected channel.
A Channel
< Mute = OFF >
UNIT MIDI PROGRAMMING
To achieve MIDI programming of your digicurve, you should have a sequencer application software (PC or MAC
platform).
It will give you the chance to automatically change a preset or a parameter of equalization filters during your
performance, inserting “Program Change” and/or “Control Change” (explained later) messages inside a MIDI
sequence.
For program change select:
Program Change
N (factory presets) =
N (user presets)=
N
“N” is the value to be used to select the corresponding preset.
In order to vary a specific parameter of a single channel of a specific preset, first select which channel equalizer
you want to modify with following procedure.
1)Program Change
N
N (preset choice) =
2)Control Change 0 (bank select) Val.
Val. (equalizer choice for each channel)=
0: channel A
1: channel B
2: channel A+B
58