Sound Processor

Proel Sound Processors User Manual
After selecting the desired item and pressing the “ENTER” button
Edit A+B Out Comp
It will be possible to edit the compressor “Threshold” parameter (from 0 to -55dB, 1dB steps) using
the “VARIATION” knob. For parameter values see TABLE 1 at page 46.
Use the ““ encoder to select “CmpRatio” parameter
Edit A+B Out Comp
Use the “VARIATION” knob to modify the ratio value of output compressor. For parameter values
see TABLE 2 at page 46.
Use the ““ encoder to select “ExpRatio” parameter
Edit A+B Out Comp
Use the “VARIATION” knob to modify the ratio value of the output expander. For parameter values
see TABLE 6 at page 47.
Use the ““ encoder to select “Release” parameter
Edit A+B Out Comp
Then use the “VARIATION” knob to modify release time (time to exit from the compression
processing when the signal is under the “Threshold”). For parameter values see TABLE 3 at page
46.
Use the ““ encoder to select “Attack” parameter
Edit A+B Out Comp
Use the “VARIATION” knob to modify attack time (time to enter the compression processing when
the signal is over the “Threshold”). For parameter values see TABLE 7 at page 47.
Turning again the ““ encoder you’ll be back to “Threshold” parameter.
To exit from this sub-menu use the “QUIT” button.
42