Sound Processor

Proel Sound Processors User Manual
CHORUS REVERB
Par 1:
Chorus rate: settles chorus rate. Range: 0% - 100%
# for Control Change 17=0
# for Control Change 16= from 0 to 100
Par 2:
% Vol Chorus: settles percentage of chorus volume. Range: 0% - 100%
# for Control Change 17=1
# for Control Change 16= from 0 to 100
Par 3:
H-Damp Freq: High frequency dampening. The value settles reverb cut-off upper frequency.
Range: 20hz to 20Khz, in 1/3 octave steps.
# for Control Change 17=2
# for Control Change 16=Table n° 4
Par 4:
Low-damp: Low frequency dampening. The value settles reverb cut-off lower frequency.
Range: 20hz to 20Khz, in 1/3 octave steps.
# for Control Change 17=3
# for Control Change 16= Table n° 4
Par 5:
PreDly Rev: Settles elapsing time from the original sound and reverb beginning.
Range: 0-200 ms (in 2 ms steps.)
# for Control Change 17=4
# for Control Change 16=Table n° 1
Par 6:
Decay: settles reverb decay time.
Range: 0-200 ms (In 2 ms steps).
# for Control Change 17=5
# for Control Change 16=Table n° 1
Par 7:
% Reverb: settles percentage of reverb effect blended to chorus. Range: 0% - 100%.
# for Control Change 17=6
# for Control Change 16= from 0 a100
Par 8:
% Vol Reverb: settles reverb master volume. Range: 0% - 100%
# for Control Change 17=7
# for Control Change 16= from 0 to 100
DELAY REVERB
Par 1:
Delay Time: settles delay time in milliseconds. Range: from 0 to 300 ms in 3 ms. steps.
# for Control Change 17=0
# for Control Change 16=Table n°2
Par 2:
Delay Decay: settles percentage of delay decay. Range: 0% - 100%
# for Control Change 17=1
# for Control Change 16= from 0 to 100
Par 3:
Delay L-Pass: Filter to cut delay high frequencies. The value settles delay cut-off upper frequency.
Range: 20hz to 20Khz, in 1/3 octave steps.
# for Control Change 17=2
# for Control Change 16= Table n°4
14