Sound Processor

Proel Sound Processors User Manual
Edit A LBand Comp
Use the ““ encoder to select “Ratio” parameter, then use the “VARIATION” knob to modify
compression ratio value (first number refers to input value, the second value refers to output value
– the meaning is “which is the compression ratio for the signal over the threshold”). For parameter
values see TABLE 2 at page 46.
Use the ““ encoder to select “Release” parameter.
Edit A LBand Comp
Then use the “VARIATION” knob to modify release time (time to exit from the compression
processing when the signal is under the “Threshold”). For parameter values see TABLE 3 at page
46.
Use the ““ encoder to select “Attack” parameter
Edit A LBand Comp
Then use the “VARIATION” knob to modify attack time (time to enter the compression processing
when the signal is over the “Threshold”). For parameter values see TABLE 4 at page 46.
Turning again the ““ encoder you’ll be back to “Threshold” parameter.
To exit from this sub-menu use the “QUIT” button.
Edit Low/High Band Volume A/B
Using these sub –menus you can edit the volume of the single selected band
Edit A Lband Vol
Use the “VARIATION” knob to modify the volume value (-/+ 6 dB, 0.5dB steps). For parameter
values see TABLE 5 at page 46.
Edit A+B Output Compressor
Using this menu you can edit Compressor-Expander parameters.
Warning! The setting of these parameters will affect both channels A and B.
Edit A+B < Out Comp >
Thr CRatio ERatio Rel Atk
41