Sound Processor
Sound Processor
Sound Processor
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Proel <strong>Sound</strong> <strong>Processor</strong>s User Manual<br />
If the system was OFF and now you select ON after button “ENTER” pressure the display will<br />
show the following warning message.<br />
Link : Are you sure?<br />
Yes = Enter; No=“QUIT”<br />
If you choose to go on, channel B content will be erased and replaced by channel A settings, thus<br />
the digicurve will function in stereo.<br />
Config Communication menu<br />
Using this utility function you can select the Config Communication, which will allow you to<br />
configure the communication with the external unit to be connected to digicurve processor<br />
Communication<br />
Device: < RS-232><br />
Using the ““ encoder you can select one of the following ports; RS-232, USB, and MIDI. Behind<br />
front panel settings, you need to select communication port by using rear panel selector switch (4).<br />
To exit from this menu press the “QUIT” button.<br />
When the processor is remotely controlled (connection by RS-232 or USB port) front panel<br />
controls are deactivated while the display shows the following message.<br />
System Lock<br />
PC connection<br />
Delay Unit menu<br />
Through this utility function the user can choose to edit delay line in meters or in seconds.<br />
Config delay unit<br />
Unit: Second<br />
Using the “VARIATION” knob it’s possible to select between: Second e Meter. To exit from this<br />
menu please use the “QUIT” button.<br />
Config Equ Type menu<br />
This function allows the user to select between parametric or graphic equalizer.<br />
Configure Equ Type<br />
Type: Parametric<br />
When the parameter is flashing you need to press the “ENTER” button to confirm it. There’s no<br />
problem passing from graphic to parametric equalizer, while passing from parametric to graphic<br />
55