 Apple Technician Guide MacBook Pro (15-inch, Mid ... - tim.id.au

More documents

Recommendations

Info

Removal 1 Remove 8.1 mm (922-9107) screw. 2 Remove cable guide assembly from case. Important: When removing the camera cable guide, do NOT remove the screw that secures the guide’s grounding clip. The clip is delicate and should remain with the guide. If the clip is damaged, install a new cable guide. Replacement Note: Be sure to anchor ground tab when reinstalling cable guide. Check that • guide’s clamp secures camera cable • ground tab attached to cable is positioned on top of holder’s screw hole • screw holes align 2010-08-05 MacBook Pro (15-inch, Mid 2010) Take Apart — Camera Cable Guide 148
Replacement Note: Be sure grounding clip fingers contact the top case. 2010-08-05 MacBook Pro (15-inch, Mid 2010) Take Apart — Camera Cable Guide 149
Page 1 and 2:
apple Apple Technician Guide MacBoo
Page 3 and 4:
MacBook Pro (15-inch, Mid 2010) Con
Page 5 and 6:
Built-in Trackpad Does Not Work 90
Page 7 and 8:
Views Exploded Views 196 Main Assem
Page 9 and 10:
2008-10-19 Manual Updates Update 11
Page 11 and 12:
apple Apple Technician Guide Basics
Page 13 and 14:
2010-08-05 Battery Precaution and T
Page 15 and 16:
2010-08-05 Serial Number Location S
Page 17 and 18:
apple Apple Technician Guide Troubl
Page 19 and 20:
2010-08-05 Hardware vs. Software Fo
Page 21 and 22:
2010-08-05 Block Diagram Refer to t
Page 23 and 24:
2010-08-05 Resetting the Parameter
Page 25 and 26:
2010-08-05 Symptom Charts Follow th
Page 27 and 28:
2010-08-05 7. Inspect MagSafe port
Page 29 and 30:
2010-08-05 4. Hold the Alt (Option)
Page 31 and 32:
2010-08-05 User-related shutdowns A
Page 33 and 34:
2010-08-05 2. Booting from known-go
Page 35 and 36:
2010-08-05 No Video/Bad Video Unlik
Page 37 and 38:
2010-08-05 9. Check for No Backligh
Page 39 and 40:
2010-08-05 5. Verify if battery sta
Page 41 and 42:
2010-08-05 Kernel Panic/System Cras
Page 43 and 44:
2010-08-05 6. Disconnect display as
Page 45 and 46:
2010-08-05 Power Adapter Issue Unli
Page 47 and 48:
2010-08-05 3. Disconnect any periph
Page 49 and 50:
2010-08-05 Battery Leaking or Swoll
Page 51 and 52:
2010-08-05 3. Verify if IP address
Page 53 and 54:
2010-08-05 Deep Dive Check Result A
Page 55 and 56:
2010-08-05 No/Poor Wireless Signal
Page 57 and 58:
2010-08-05 Bluetooth Wireless Input
Page 59 and 60:
2010-08-05 AirPort Card: Kernel Pan
Page 61 and 62:
2010-08-05 2. Turn off Bluetooth. R
Page 63 and 64:
2010-08-05 5. Verify if Bluetooth a
Page 65 and 66:
2010-08-05 Deep Dive: Incorrect/Mis
Page 67 and 68:
2010-08-05 Deep Dive: Vertical/Hori
Page 69 and 70:
2010-08-05 Defective Camera / Built
Page 71 and 72:
2010-08-05 6. Substitute with a kno
Page 73 and 74:
2010-08-05 Noise / Unstable Flicker
Page 75 and 76:
2010-08-05 Mass Storage Hard Drive
Page 77 and 78:
Page 79 and 80:
2010-08-05 5. After installing new
Page 81 and 82:
2010-08-05 7. Verify if optical med
Page 83 and 84:
Page 85 and 86:
2010-08-05 7. Disc spin should ceas
Page 87 and 88:
2010-08-05 Input/Output Devices USB
Page 89 and 90:
2010-08-05 4. Reseat cable and chec
Page 91 and 92:
2010-08-05 7. Verify if a known-goo
Page 93 and 94:
2010-08-05 Built-in Keyboard Is Not
Page 95 and 96:
2010-08-05 5. Verify if the trackpa
Page 97 and 98: 2010-08-05 2. Play some music and p
Page 99 and 100: 2010-08-05 Audio: Microphone Unlike
Page 101 and 102: 2010-08-05 Deep Dive Check Result A
Page 103 and 104: 2010-08-05 Deep Dive Check Result A
Page 105 and 106: 2010-08-05 Mechanical Issues: Therm
Page 107 and 108: 2010-08-05 System Runs Hot Unlikely
Page 109 and 110: apple Apple Technician Guide Take A
Page 111 and 112: Horizontal Install • Pull connect
Page 113 and 114: Battery Precaution This computer co
Page 115 and 116: First Steps Warning: • Shut down
Page 117 and 118: 2 Remove 10 screws: • 3 (14 mm) 9
Page 119 and 120: First Steps Remove: • Bottom case
Page 121 and 122: 3 Using a black stick, pry cable fr
Page 125 and 126: 3 Use pull tab to tilt hard drive o
Page 127 and 128: Replacement 1 Touch a metal surface
Page 129 and 130: 2010-08-05 Reinstalling Software Th
Page 131 and 132: Removal 1 Caution: The cable is fra
Page 133 and 134: Memory Information Memory cards mus
Page 139 and 140: 2 Remove 2 screws: • 1 (8.1 mm) 9
Page 141 and 142: 6 If you are removing card holder f
Page 143 and 144: First Steps Do the following: • R
Page 145 and 146: First Steps Do the following: • R
Page 147: First Steps Do the following: • R
Page 151 and 152: Removal 1 Remove 6.5 mm (922-8645)
Page 155 and 156: 4 Open the display to 90 degrees, a
Page 157 and 158: Removal 1 Cover display face with c
Page 159 and 160: 3 Position clutch cover onto end wi
Page 161 and 162: Removal 1 Using black stick, discon
Page 163 and 164: Reassembly Note: Inspect the top an
Page 165 and 166: Removal 1 Use a black stick to disc
Page 167 and 168: Removal 1 Use a black stick to pry
Page 169 and 170: Removal Caution: The LVDS cable/ lo
Page 171 and 172: 6 Remove 7 (3.0 mm) 922-9108 Torx T
Page 175 and 176: Replacement Important: New heatsink
Page 177 and 178: Removal 1 Carefully peel up trackpa
Page 179 and 180: Replacement 1 Route flex cable thro
Page 181 and 182: 6 Turn top case over. Tighten screw
Page 183 and 184: Removal 1 Carefully peel back tape
Page 185 and 186: Removal Use black stick to pry micr
Page 187 and 188: Removal 1 Remove 2 (7.5 mm) 922-904
Page 189 and 190: Removal 1 Place tape over battery b
Page 191 and 192: Removal 1 Remove 2 screws: • 1 (9
Page 193 and 194: Removal With the first steps comple
Page 195 and 196: apple Apple Technician Guide Views
Page 197 and 198: 2010-08-05 Main Assembly 2 Bottom C
Page 199 and 200:
2010-08-05 External Views Front Vie
Page 201 and 202:
Bottom Case 3 (14 mm) 922-8985 7 (3
Page 203 and 204:
AirPort/Bluetooth Card Holder 1 (8.
Page 205 and 206:
Display Assembly 6 (5.3 mm) 922-864
Page 207 and 208:
Heatsink 6 (8 mm) 922-9328 Torx T6
Page 209 and 210:
Battery Indicator Light Board 3 (1.
Page 211:
2008-08-27 922-9094 Phillips #00 Ri
show all

 Apple Technician Guide MacBook Pro (15-inch, Mid ... - tim.id.au

Create successful ePaper yourself

Delete template?

Save as template?